 
Easy to Use - Directions
Asphalt Patch™ (Type HP) can be used in any type
of weather; hot or cold; wet or dry. Sweep hole clean, remove
all loose pavement around edges, and sweep out standing water
from hole. Note: A wet surface will not affect adhesion.
Fill with Asphalt Patch™ (Type HP) to a slight
crown to allow for compaction. If a hole is deeper than 2",
fill with Asphalt Patch™ (Type HP) in 2" layers
and tamp each layer. Compact with tamper, shovel or drive
over repaired area. Asphalt Patch™ (Type HP) will
not adhere to tires. Vehicle access is immediate, even though
patch may take several days to completely dry. To shorten
drying time and to prevent tracking in hot weather, sprinkle
surface dirt or sand on repaired surface. No sealer needs
to be applied. Do not tamper with patch during setting process.
After using Asphalt Patch™ (Type HP) store in
bag by twisting top & wrapping with tape. Used for quick
and easy repairs on paved surfaces of driveways, parking lots,
utility cuts, walks and all asphalt and cement surfaces.
Note: this product can be used for expansion joint material.
(Directions: Place Asphalt Patch™ (Type HP) in
expansion joint and compact using edge of board.)
Note:Asphalt Patch™ (Type HP) saves you money
by cutting down on frequent patching.
IMPORTANT:
Use type HP if pothole needs to be repaired while still
wet; type I for dry pothole and to match old asphalt. |
Asphalt Patch™ is guaranteed to
be free from defects in material and workmanship. Obligation is limited to the
replacement of material shown to be defective.
Net Weight: 60
lbs.
Coverage: Approx.
5.4 sq. ft. 1" deep |
|
